Instructions for rotating the gear box on T-MAX Winches

In some applications it will be necessary to rotate the gearbox so you can reach the clutch handle through the bullbar.

Step One
Remove the two 6mm tie bar bolts above the gearbox and then the gearbox can be removed as one piece.

Step two
Inside the gearbox there are nine 3mm Allen bolts to be removed.

Step three
Once the nine 3mm Allen bolts have been removed, the gear box can then be rotated in 30 degree increments until the desired position is achieved.

Step Four
Replace the nine 3mm Allen bolts and then the gearbox can be refitted to the winch.

Step five
Replace the two 6mm tie bar bolts and the job is complete.